Every time I start my computer I have to check the connection of the VCI scanner to the VCI manager and check the connection and only then start the software for the vehicle (Benz or BMW) BMW connects in a short time, and when I start the Benz software I have to wait up to 5 minutes. I have a VXdiag All scanner and software and a license for BMW and BENZ. If your vcm not show it is a bad install or a bad vcm Then do select all other and next it should bring up a screen of available interfaces You should then see a red icon in bottom right corner that shows vcm is connectedĬonnect to a car (any car) so that vcm has power from car Wait a few 3-5 mins so that windows has completed all its start up checks etc If vcm is connected to vci manager it will not connect to ids I installed VCI software 1.0.and VCI manager. I would like to know do I have to click on ‘Connect’ every time in VCI manager before using IDS? But when I test to see if it’s communicating with the software IDS, it does not seem to work. When I double-click on VCI manager, and click ‘connect’ it works and you can hear a beep noise. All good but I have not connected to a car yet. Question: I managed to install the IDS software v116 that came with the clone Ford VCM2 VCI that I bought recently.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |